Metadata-Version: 1.0
Name: wiringpi2
Version: 1.0.6
Summary: A python interface to WiringPi 2.0 library which allows for
    easily interfacing with the GPIO pins of the Raspberry Pi. Also supports
    i2c and SPI
Home-page: https://github.com/Gadgetoid/WiringPi2-Python/
Author: Philip Howard
Author-email: phil@gadgetoid.com
License: UNKNOWN
Description: ======
        WiringPi 2 for Python
        ======
        
        WARNING: This is an in-development library, it will not be bug free and fully featured.
        ======
        
        Please tweet @gadgetoid, find Gadgetoid in IRC, email Phil at Gadgetoid dot com,
        or visit http://pi.gadgetoid.com/post/039-wiringpi-version-2-with-extra-python and
        comment if you have any problems, suggestions, questions or words of support.
        
        WiringPi: An implementation of most of the Arduino Wiring
        	functions for the Raspberry Pi
        
        WiringPi2: WiringPi version 2 implements new functions for managing IO expanders.
        
        Testing:
        ========
        Build with gcc version 4.6.3 (Debian 4.6.3-14+rpi1)
        Built against Python 2.7.2, Python 3.2.3
        
        Prerequisites:
        ==============
        You must have python-dev and python-setuptools installed
        If you manually rebuild the bindings with swig -python wiringpi.i
        
        Get/setup repo:
        ===============
        git clone https://github.com/Gadgetoid/WiringPi2-Python.git
        cd WiringPi2-Python
        
        Build & install with:
        =====================
        sudo python setup.py install
        
        Or Python 3
        sudo python3 setup.py install
        
        Class-based Usage:
        ==================
        Description incoming!
        
        Usage:
        ======
        import wiringpi2
        wiringpi2.wiringPiSetup // For sequential pin numbering, one of these MUST be called before using IO functions
        OR
        wiringpi2.wiringPiSetupSys // For /sys/class/gpio with GPIO pin numbering
        OR
        wiringpi2.wiringPiSetupGpio // For GPIO pin numbering
        
        Setting up IO expanders (This example was tested on a quick2wire board with one digital IO expansion board connected via I2C):
        wiringpi2.mcp23017Setup(65,0x20)
        wiringpi2.pinMode(65,1)
        wiringpi2.digitalWrite(65,1)
        
        General IO:
        -----------
        wiringpi2.pinMode(1,1) // Set pin 1 to output
        wiringpi2.digitalWrite(1,1) // Write 1 HIGH to pin 1
        wiringpi2.digitalRead(1) // Read pin 1
        
        Bit shifting:
        -------------
        wiringpi2.shiftOut(1,2,0,123) // Shift out 123 (b1110110, byte 0-255) to data pin 1, clock pin 2
        
        Serial:
        -------
        serial = wiringpi2.serialOpen('/dev/ttyAMA0',9600) // Requires device/baud and returns an ID
        wiringpi2.serialPuts(serial,"hello")
        wiringpi2.serialClose(serial) // Pass in ID
        
        Full details at:
        ----------------
        http://www.wiringpi.com
        
Platform: UNKNOWN
